Attaching/Removing the Stand

Removing the Stand

The stand section of this product can be removed.

Attention

  • Do not move the stand up and down after removing it. If you move the stand up and down while it is not attached to the monitor, this may cause damage or injury.
  • If you drop the monitor or stand, this may cause damage or injury due to the weight of the monitor and stand.

 

  1. Raise the height of the monitor to the maximum height.

  2. Attention

    • If the monitor is not raised to the maximum height, there may be cases when the height of the monitor accidentally changes while removing the stand. This may be the cause of injury or damage.
  3. Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the LCD panel surface facing down.
  4. Remove the stand.
  5. As shown in the diagram, press the lock button (1) while holding firmly onto the brace of the stand, and slide the stand in the direction of the pedestal on the bottom (2). Next, pull the stand upwards to remove it (3).

Attaching the Optional Arm

The optional arm (or optional stand) can be attached by removing the stand section. Please refer to our web site for the supported optional arms (or optional stands).

(www.eizoglobal.com )

When attaching an arm or stand, the installable orientations and movement range (tilt angle) are as follows:

Attention

  • When attaching an arm or stand, follow the instructions of the respective User’s Manual.
  • When using another manufacturer’s arm or stand, confirm the following in advance and select one that conforms to the VESA standard:
  • Clearance between screw holes: 100 mm x 100 mm
  • Arm or stand VESA mount dimensions: 122 mm x 122 mm or less
  • Plate thickness: 2.6 mm
  • Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables
  • Connect the cables after attaching an arm or stand.
  • Do not move the removed stand up and down. Doing so may result in injury or device damage.
  • The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
  • Periodically check the tightness of the screws. If the screws are not tight enough, the monitor may come unattached. This may be the cause of injury or damage.
  1. Attach the arm or stand to the monitor.
  2. For installation, use commercially available screws that meet the following conditions:
  3. Nominal diameter: M4
  4. Length: Between 8.4 mm and 12.9 mm (if using washers, add the washer thickness)

Attaching the Original Stand

  1. Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the LCD panel surface facing down.
  2. Remove the fixing screws on the optional arm (or optional stand), and detach the optional arm (or optional stand).
  3. Attach the original stand.
  4. Insert the four tabs on the stand into the four holes on the back panel (1), and slide the stand towards the upper portion of the monitor (2). The stand clicks when it is attached correctly. Check that the stand is properly attached by pushing it side to side and back to front.